"Do's" & "Don'ts"

• Always clean aluminium conductors
• Always apply the correct jointing compound
• Always insert conductor/s fully and/or equally into fitting
• Always use the correct compression die - if in doubt, CHECK
• Always compress all the area provided
• Always clean off any excess compound
• Always use peg dies with solid aluminium conductors
• Never use EP Unigrip C compound with bolted connections
• Never use EP Unigrip C compound on copper conductors
• Never bolt aluminium to copper without using EP Jointseal compound and preferably Belleville Washers/Transition Plate
• Never use incorrect fittings
• Never use incorrect compression dies

Product Labelling

Ail Electropar compression products are either stamped or labelled for easy identification. Labels feature important installation information and typically include the following details:
• Product Type
• Installation Instructions
• Catalogue Number
• Conductor Size/s
• Compression Die Size
Should you require special references or part numbers to be featured on the label of any Electropar product, this service is available.
Conductor Preparation
• Before attempting to make any joint in aluminium, aluminium alloy or ACSR conductors, it is of the utmost importance that conductor ends are in good condition, clean and free from all defects and sharp edges. This especially applies to joints or line taps being fitted to older, existing conductors.
• If conductors ends are damaged, cut away the damaged section before attempting to make a new connection.
• If necessary, unlay outer strands to give access to inner strands for cleaning.
• Clean and dry the aluminium conductor with a stainless steel wire brush and immediately apply an appropriate EP jointing compound to prevent re-oxidisation. It is good practice to brush the jointing compound onto the conductor.

Fitting Joint Instructions

FI.01D - ACSR COMPRESSION DEADENDS (AT 18-11-11)

FI.02D - ACSR COMPRESSION MIDSPANS (AT 18-11-11)