Jumper Terminals

For Terminating Aluminium Conductors

Electropar's jumper terminals are supplied with two bolt holes at a 30° palm angle as standard. Three and four bolt hole styles are also available. All jumper terminal styles can be supplied at any palm angle from 0° to 90°. Where jumper terminals are required to mate with an existing fitting, always specify palm bolt size and hole centres required.
Jumper terminals are pre-filled with EP Uniseal or Unigrip C jointing compound, capped, individually labelled and sealed in plastic packs. Compression of the fittings can be done with conventional hexagonal aluminium DA dies.
Belleville washers are recommended to ensure constant bolt pressure on the palm joint.
* Note : Goat and Zebra Jumper Terminals are 3 Bolt as standard.
 
RECOMMENDED FOR HV OR LV TERMINATIONS

CATALOGUE NUMBER
DIMENSIONS mm

HEXAGONAL COMPRESSION DIE NUMBER
APPROX WEIGHT gm
D
W
B
T
C
E
EPJT - Ferret - 5
20.6
35
102
8
49
M12
DA 5
190
EPJT - Flourine - 5
20.6
35
102
8
49
M12
DA 5
190
EPJT-Mink- 6
25.4
35
102
8
49
M12
DA 6
217
EPJT - Wasp - 6
25.4
35
102
8
49
M12
DA 6
217
EPJT - Cricket - 6
25.4
35
102
8
49
M12
DA 6
217
EPJT - Hydrogen - 6
25.4
35
102
8
49
M12
DA6
217
EPJT - Helium - 6
25.4
35
102
8
49
M12
DA 6
217
EPJT-Dog -7
30.2
35
111
11
49
M16
DA 7
345
EPJT-Dingo-7
30.2
35
111
11
49
M16
DA 7
338
EPJT - Weke - 7
30.2
35
111
11
49
M16
DA 7
345
EPJT - Coyote - 7
30.2
35
111
11
49
M16
DA 7
350
EPJT - Hyena - 7
30.2
35
111
11
49
M16
DA 7
324

Similar Products